User manual

3–7
Chapter 3 – Installation and Wiring
LT Series User Manual
1. Make sure that the LT unit’s power cord is not plugged in to the power supply.
2. Remove the Terminal Strip’s clear plastic cover.
3. Remove the screws from the three (3) middle terminals, position the Ring
Terminals (see below), and reattach the screws. Check each wire to make sure
the connections are correct, and use only 0.5 to 0.6 N•m of force.
Rear of the LT Unit
Power Terminal Block
FG
–
+
+–FG
Crimp-on Ring Terminals


 Connecting the Power Supply Terminals
4. Reattach the Terminal Strip’s clear plastic cover.
DC 24V