User manual

3–5
Chapter 3 – Installation and Wiring
LT Series User Manual
5. Use a Phillips screwdriver to tighten each fastener screw and secure the LT in
place.
A torque of only 0.5 to 0.6 N•m is sufficient to tighten these screws.
Excessive force may damage the LT unit.
3. Insert each of the fasteners as follows.
4. Be sure to pull the fastener back until it is flush with the rear of the attachment
hole:
Depending on the condition of the panel, increasing the num-
ber of installation fasteners will raise the level of water resis-
tance.
Installation Panel
Hook