User manual

Chapter 3 – Installation and Wiring
3–2 LT Series User Manual


 Creating a Panel Cut
Create an opening with the correct dimensions to install the LT.
For the correct installation dimensions, see Section 2.5.3 – “LT Panel
Cut Dimensions.”
The installation gasket, installation fasteners, and attachment screws are all re-
quired when installing the LT.
Make sure that the installation panel or cabinet’s surface is
flat, in good condition, and has no jagged edges. Metal rein-
forcement strips can also be attached to the inside of the panel,
near the Panel Cut, to increase the panel’s strength.
For easier maintenance and operation, and improved ventilation, install
the LT at least 100 mm (3.94 in.) away from adjacent structures and
other equipment.
Panel thickness should be between 1.6 and 5.0 mm (0.06 to 0.02 in.),
and should be based on the strength required to mount the LT to the
panel.
Panel Cut
Area
Panel
Unit: mm [in]
100
[3.94]
100
[3.94]
100
[3.94]
100
[3.94]
100
[3.94]
100
[3.94]
100
[3.94]