User manual

Chapter 2 – Specifications
LT Series User Manual2–18
 Recommended Connectors and Covers
Digital has prepared sets of connectors and connector covers (GLC100-DIOCN01:
5 sets) and a ribbon cable crimp connector (GLC-DIOCN02: 5/set).
Section 1.3 – “Accessories”
For other types of connections, Pro-face recommends the items listed below.
Connection
Method
Corresponding Connectors
(manufactured by Fujitsu Takamisawa Component Limited)
Solder
FCN-361J040-AU (Connector)
FCN-360C040-B (Cover)
Crimp
FCN-363J040 (Connector)
FCN-363J040-AU/S (Contact)
FCN-360C040-B (Cover)
Pre ssure W eld
FCN-367J040-AU/F (Contact)
Recommended Cable:
Flat Cable (1.27mm pitch)
AWG#28 (Lay wire) / AWG#30 (Solid wire)
♦ Output Specifications (Type B+)
Rated Voltage
DC 24V
Rated Voltage Range
DC 24V ±10%
Output Method
Sink Output
Maximum Load Voltage
0.2 A/point 1.6 A/common
Output Voltage Drop
1.5V or less
Output Delay Time
OFF to ON: 1ms or less
ON to OFF: 1 ms or less
Voltage Leakage (when OFF)
0.1 mA or less
Type of Output
Transistor Output
Common Lines
1
Common Design
16 points/1 common line
External Connection
40-pin connector (also used for Input)
Output Protection Type
Output is unprotected
Internal Fuse
3.5 A, 125V Chip Fuse (non-replaceable)
Surge Control Circuit
Diode
Output Points
16
Output Signal Display
LED lights when each point turns ON (logical side)
Status Display Element
None
Isolation Method
Photocoupler Isolation
External Power Supply
DC 24V
 Recommended Wiring
Equivalent to AWG#22.