User manual

Chapter 1 – Introduction
LT Series User Manual 1–7


 Recommended Units
The following tables list I/O devices that have been confirmed to be compatible
with the LT. If you connect a device other than those listed below, be sure to
confirm that the connection functions correctly using an actual unit.
Recommended units are subject to change without no-
tice.
Bar code readers (Connected to Tool Connector)
*1 Be sure to use the Y cable included with the unit and connect it between the LT unit
and a bar code reader. Data cannot be read correctly, if a non-"Y" cable is used, or if
the bar code reader is connected directly to the LT unit.
*2 The following settings must be entered prior to using the bar code reader with a LT
unit.
1) Set the CAPS.
2) Add the Carriage Return (CR) in the Postamble's settings.
For the details about these settings, please refer to the Installation Guide included
with the bar code reader unit.
BCK5435-STA Touch Scanner (Read Width: 56mm)
*1*2
BCK5535-STA Touch Scanner (Read Width: 85mm)
*1*2
NEC Infrontia