User manual

6–15
Chapter 6 – Initializing the LT
LT Series User Manual
PERCENT ALLOCATION
Use Percent Allocation to set the ratio of Controller Operation Time Function in
Target Scan Time. The setting range for Percent Allocation is between 0 and 50%.
When Percent Allocation is set, Target Scan is disabled.
LT Editor Operation Manual – Logic Programming Guide (included
with the LT Editor software), Pro-Control Editor User Manual (in-
cluded with the C-Package software)
CONTROLLER STATE
This item sets the Operation Mode — Default, Run, or Stop — when the power is
ON.
The Controller State setting is valid only when the RUN/STOP switch on the back
of LT is set to Run. When the switch is set to Stop, the Operation Mode will
always be Stop, regardless of this setting’s value.
STOP ON MINOR FAULT
This item either stops the Controller or executes a logic program when a minor
fault occurs. If you wish operation to continue after a fault occurs, set this switch
to Continue; if you wish to stop operation, set it to Stop.
LT Editor Online Help, Pro-Control Editor Online Help
WATCHDOG TIMER
Sets the Watch Dog Timer (WDT) for the Controller Operation Time and the LT
Operation Time functions to between 100 and 3000 ms. Input the value in units of
100 ms. Inputting “0” is invalid.
CONTROLLER SETTING 2
CHANGE SCREEN CHECK
After #Screen is used to perform the screen change, the #Screen setting value is
reset to “0”. Using the ON (initial) setting will clear the #Screen value to “0”.
LT Editor Operation Manual – Logic Programming Guide (included
with the LT Editor), Pro-Control Editor User Manual (included with
the C-Package software)


 CTRL DIAGNOSIS
Section 7.3.3 – “List of Controller Self-Diagnostics Items”


 I/O DRIVER
The supported driver type depends on the LT type. Types A1 and A2 support the
DIO driver, and types B, B+ and C support the Flex Network Driver. The logic
program that configures each I/O driver will be downloaded.
LT Editor Operation Manual – Logic Programming Guide (included
with the LT Editor), Pro-Control Editor Operation Manual (included
with the C-Package software)