Hardware manual

LT-4201TM/4301TM Hardware Manual

Connecting the Power Cord

The table explains how to connect the power plug:

NOTE:

z Do not solder the wire directly to the power receptacle pin.

z The power supply cord must meet the specification shown above. Twist the

power cords together, up to the power plug, for EMC compliance.

z Use field wiring terminal marking for wire type (75 °C (167 °F) copper conductors

only).

Step Action

1 Confirm the power cord is not connected to the power supply.

2 Check the r

ated voltage and remove the "DC24V" sticker on the DC power

supply connector

3 Remove 10 mm (0.39 in.) of the vinyl membrane off the ends of the power code

wore

4 If using stranded wire, twist the ends. Tinning the ends with solder redu

ces risk

of fraying and ensures good electrical transfer.

5 Push the Opening button with a small and flat screwdriver to open the desired

in hole.

6 Insert each pin terminal into its corresponding hole. Release the O

pening button

to clamp the pin in place.

7 After inserting all three pins, insert the power plug into the power connector

the LT.

9

'&3RZHU&RUG

2SHQLQJ%XWWRQ

9