Hardware manual

LT-4201TM/4301TM Hardware Manual
73
Installing and Removing the Rear Module on a DIN Rail
Overview
This section describes how to install and remove the rear module on a DIN rail.
Installing the Rear Module on a DIN Rail
The following procedure describes how
to install
the rear module on a DIN rail:
WARNING
EXPLOSION HAZARD
z Do not connect or disconnect while circuit is live.
z Potential electrostatic charging hazard: wipe the front panel of the terminal with
a damp cloth before turning ON.
Failure to follow these instructions can result in death, serious injury, or
e
qu
ipment damage.
Step Action
1 Using screws, to fasten the DIN rail to a panel surfaces.
2 Affix the display module/rear module sepa
ration cable to the rear module.
3 Position the top groove of the rear module on the top edge of the DIN rail and
pr
ess the assembly against the DIN rail until you hear the DIN rail clip click into
place.