Hardware manual

LT Installation

z The power plug is positioned vertically when the unit is vertically installed.

z The unit is at least 100 mm (3.94 in.) away from adjacent structures and other

equipment for easier maintenance, operation, and improved ventilation:

Step Action

1 Place the unit on a clean and level surface with the display panel facing

downward.

2 The sup

port thickness depends on the material:

z Steel sheet: between 1.5 and 6 mm (0.059 in. and 0.236 in.)

z Plastic: between 3 and 6 mm (0.118 in. and 0.236 in.)

If the thickness is between 1 and 1.5 mm (0.039 in. and 0.059 in.) for a steel

sheet support or between 1

mm and 3 mm (0.039 in. and 0.118 in.) for plastic,

use the spacer supplied in accessory kit PFXZGMAK1 (sold separ

ately).

3 Create the correct sized holes required to install the unit, using the Panel Cut-

Out Dimension and Inst

allation (see page 61).