Hardware manual

LT-4201TM/4301TM Hardware Manual
65
LT Setup Procedure
Mount the unit in an enclosure that provides a clean, dry, robust, and controlled
environment (IP65 enclosure or UL508 4x, if indoors). (see page 31)
Before installing the
L
T verify that:
z The installation panel or cabinet surface is flat (planarity tolerance: 0.5 mm
(0.019 in.)), in good condition and has no jagged edges. Metal reinforcing strips
may be attached to the inside of the panel, near the panel cut-out, to increase the
rigidity.
z The panel is designed to avoid any induced vibration resonance on the rear
module exceeding a punctual factor of 10 and avoids any induced permanent
vibration resonance.
To reduce the resonance use the panel adaptor accessory.
z The ambient operating temperature and the ambient humidity are within their
specified ranges (see page 31). (When installing the panel in a cabinet or
enclosure, the ambient operation temperature is the internal temperature of the
ca
binet or enclosure.)
z The heat from surrounding equipment does not cause the unit to exceed its
specified operating temperature (see page 31).
z When installing the display module in a vertical position (portrait view), the logo
on the display face must be on the right side to keep the power connector at the
top:
NOTE: For use in Pollution Degree 2 environments.
z The panel face is not inclined more than 30° when installing the unit in a slanted
panel: