Hardware manual

LT-4201TM/4301TM Hardware Manual
41
Protective Earth Ground (PE)
The following shows the steps when using shield cables for grounding the LT power
supply, Standard Input/Output, High-speed Input/Output, Analog Input/Output,
Temperature Input, Communication cable so on.
NOTE: The shielding must be clamped securely to the conductive backplane to
ensure a good contact.
Step Description
1 Strip the shielding for a length of
15 mm (0.59 in.)
2 Use the metal grounding clamp
(2) to attach the cable to the
backplane plate (1
) as close as
possible to the LT.