Hardware manual

LT System General Rules for Implementing

WARNING

UNINTENDED EQUIPMENT OPERATION

z Use appropriate safety interlocks where personnel and/or equipment hazards

exist.

z Install and operate this equipment in an enclosure appropriately rated for its

intended environment.

z Use the sensor and actuator power supplies only for supplying power to the

sensors or actuators connected to the module.

z Power line and output circuits must be wired and fused in compliance with local

and national regulatory requirements for the rated current and voltage of the

particular equipment.

z Do not use this equipment in safety-critical machine functions.

z Do not disassemble, repair, or modify this equipment.

z Do not connect any wiring to unused connections, or to connections designated

as Not Connected (N.C.).

Failure to follow these instructions can result in death, serious injury, or

equipme

nt damage.