Hardware manual

LT System General Rules for Implementing

Before energizing equipment:

z Remove tools, meters, and debris from equipment.

z Close the equipment enclosure door.

z Remove ground from incoming power lines.

z Perform all start-up tests recommended by the manufacturer.

Operation and Adjustments

There are hazards that can be encountered if this equipment is improp

erly o

perated

or adjusted, regardless of the care exercised in the design and manufacture of

equipment or in the selection and ratings of components. It may be possible to mis-

adjust this equipment and thereby produce unintended consequences. Only those

operational adjustments required by the operator should be accessible to the

operator. Access to other controls should be restricted to prevent unauthorized

changes in operating characteristics or machine behavior. Restrict access to such

adjustments only to qualified personnel familiar with the machinery in use, and

familiar with the instructions of equipment manufacturers for all of the electrical

equipment employed. Use the instructions from the manufacturers as a guide for

functional, electrical, or other like adjustments.