Installation guide

5
 DIO Interface (Connector)
• When preparing the cable to connect the wiring, check the pin numbers inscribed on
the DIO Connector.
• Parenthesized signal names ( ) indicate when Pulse output (PLS∗), PWM output (PWM∗), or
Counter Input (CT∗) are used.
Applicable connector
2-1871940-9 <Tyco Electronics AMP.>
CA7-DIOCN5-01 <Pro-face>
Pin Arrangement Pin No. Signal Name Pin No. Signal Name
A1 IN1 B1 IN0 (CT0)
A2 IN3 B2 IN2 (CT1)
A3 IN5 B3 IN4 (CT2)
A4 IN7 B4 IN6 (CT3)
A5 IN9 B5 IN8
A6 IN11 B6 IN10
A7 IN13 B7 IN12
A8 IN15 B8 IN14
A9 NC B9 COM
A10
Sink: NC
B10
Sink: +24V
Source: +24V Source: +24V
A11
Sink: 0V
B11
Sink: 0V
Source: NC Source: 0V
A12
OUT1
(PLS1, PWM1)
B12
OUT0
(PLS0, PWM0)
A13
OUT3
(PLS3, PWM3)
B13
OUT2
(PLS2, PWM2)
A14 OUT5 B14 OUT4
A15 OUT7 B15 OUT6
A16 OUT9 B16 OUT8
A17 OUT11 B17 OUT10
A18OUT13B18OUT12
A19OUT15B19OUT14
(Cable connection side)
A1
B1
B19
A19