Installation guide

16
COUPER LE COURANT OU
S’ASSURER QUE L’EMPLACEMENT
EST DESIGNE NON DANGEREUX”.
(5) In the case of use in Hazardous Locations, be
sure to check that the externally connected
unit and each interface have been fixed with
screws and locked.
In Hazardous Locations, it’s impossible to
insert or pull the cable from the applicable
port. Be sure to check that the location is
Non-Hazardous before inserting or pulling it.
*1 Rev.1 or later are all ANSI/ISA-12.12.01-2007
compliant.
Revision (page 16)
CE Marking
• The following units are CE marked prod-
ucts complying with the EMC Directive.
These units also conform to EN55011 Class
A, EN61000-6-2 directives.
Revision
The revision number of the LT is shown in the
label affixed to the LT. In the example shown
below, an asterisk “*” is displayed in the position
where “A” should be, meaning “Rev. A”.
Digital Electronics Corporation
8-2-52 Nanko-higashi
Suminoe-ku, Osaka 559-0031
JAPAN
TEL: [phone]
FAX: [phone]
http://www.pro-face.com/
© Copyright 2007 Digital Electronics Corporation. All
rights reserved.
PFX104831G .LT3300-MT02E-BTH
2010.11 JM/B
SEE
LT3300-S1-D24-K LT3300-S1-D24-C
LT3300-L1-D24-K LT3300-L1-D24-C
LT3301-L1-D24-K LT3301-L1-D24-C
Inquiry
Do you have any questions about
difficulties with this product?
Please access our site anytime that
you need help with a solution.
http://www.pro-face.com/otasuke/
Please be aware that Digital Electronics Corporation
shall not be held liable by the user for any damages,
losses, or third party claims arising from the uses of
this product.
Note