User`s manual

Chapter 5 - Initializing the GP
GP-477R/577R Series User's Manual 5-11
Touch operation and Force Reset setup, and Display Device adjustments are
made here.
TOUCH OPERATION MODE
Designates either One Point, Two Point or No Slide. When No Slide is
selected, dragging one's finger across the touch screen will elicit no screen
response, and only individually selected points will register.
FORCE RESET
Set up whether or not a FORCE RESET operation is in effect.
Steps to run FORCE RESET
While holding down the bottom right corner (1) of the screen, press the
upper right corner (2). At the same time, press the bottom left corner (3) to
enter the FORCE RESET Operation. To activate Reset, press the RESET
button, to transfer to OFFLINE Mode, press OFFLINE.
• FORCE RESET can occur during either RUN mode or OFFLINE
mode.
• The FORCE RESET mode cannot be entered while the GP is
starting up.
• Entering FORCE RESET is possible even when RUN opera-
tions (PLC <—>GP communication) are not being performed.
!!
!!
!
3. SET UP TOUCH PANEL
!!
!!
!
Important