User`s manual

Chapter 4 - OFFLINE Mode
GP-477R/577R Series User's Manual 4-3
Each menu item shown below has different settings that must be set to
match the corresponding PLC in order for the GP to communicate properly.
Entering OFFLINE mode calls up the following screen.
INITIALIZE
The setup items listed in this menu are necessary to run the GP unit.
SCREEN DATA TRANSFER
Select to transfer screen data to and from the screen editing software.
SELF-DIAGNOSIS
Checks to see if there are any problems with the GP System or Interface (I/F).
RUN
Starts GP operation.
For more information about INITIALIZE, refer to Chapter
5, "Initialize"; for more information about TRANSFER SCREEN DATA, refer
to your screen editor software's Operation Manual; for more information
about SELF-DIAGNOSIS and RUN, refer to Chapter 6, "GP Run Mode and
Errors".
Reference
4.2 OFFLINE Mode's Main Menu
Select the desired menu item by pressing the corresponding number on the
screen.
Each Main Menu item is used as follows.