User`s manual

Chapter 3 - Installation and Wiring
GP-477R/577R Series User's Manual
3-10
Tool Connector
Socket
3) Connect the cable to your
printer, using the same proce-
dures outlined in steps 1 and 2.
(For the correct printer cable to use
with this unit, please contact your
nearest Digital representative)
The GP's Data Transfer Cable, Memory Loader II, or the Bar Code Reader can be
attached to the GP's Tool Connector socket.
• Before unplugging any connector(s) from the back of the GP, be sure
the GP's power cable is unplugged from the main power supply.
• When the Bar Code Reader uses a separate power supply:
- Turn the Bar Code Reader ON before turning the GP ON.
- Turn the GP OFF before turning the Bar Code Reader OFF.
GP-577R Series (rear face)
GP-477R Series (rear face)
!!
!!
!
Important
3.4 GP Tool Connector