User`s manual

Chapter 3 - Installation and Wiring
GP-477R/577R Series User's Manual 3-9
Input and output signal lines must be separated from the power control cables
for operating circuits.
If this is not possible, use a shielded cable and connect the shield to the GP's
frame.
The steps to connect a printer to the GP are outlined below.
(A commercially available 14 pin Centronix printer cable is required)
GP-577R Series (rear face)
GP-477R Series (rear face)
Printer Interface
(Printer Cable Connector)
1) Connect the 14 pin end of the
cable to the GP.
2) Secure the cable by squeezing
the connector's two(2) side
pinch-clips until they lock into
place.
5. Placement of I/O Signal Lines
3.3 Connecting the Printer Cable