User`s manual

GP-477R/577R Series User's Manual 3-1

Chapter 3

Installation and Wiring

1. Installation 3. Connecting the Printer Cable

2. Wiring Cautions 4. GP Tool Connector

3.1 Installation

1. Creating an Installation Opening

Create the correct sized opening required to install the GP, using the installation

dimensions given.

2.5.4 “GP Installation Mounting Hole Dimensions”

The mositure resistant gasket, installation brackets and attachment screws are all

required when installing the GP.

• Check that the panel or cabinet's surface is flat, in good condition, and has no

jagged edges.

• Panel thickness should be from 1.6mm to 10.0mm.

Installation

gasket

Rear

face

Note:

It is strongly recommended that you use the gasket.

Place the GP on a level surface with the display panel

facing downward. Check that the GP’s installation

gasket is seated securely into the gasket’s groove,

which runs around the perimeter of the panel’s frame.

For details about installing the gasket, refer to

7.1.2 Installation Gasket Replace-

ment

Follow the steps given below when installing the GP unit.

n Confirm the Installation Gasket’s Seating

Before installing the GP into a cabinet or panel, check that the

installation gasket is securely attached to the unit.

1.6 to 10mm