User`s manual

Chapter 1 - Introduction
GP-477R/577R Series User's Manual
1-4
All optional equipment listed below is produced by the Digital Electronics Co.
ITEM DESCRIPTION
Software
GP-PRO/PBIII for Windows *1
(GPW-PB01J-V* <CD-ROM>
Screen creation software for GP units
Data Transfer Cable Set *2
(GPW-CB02)
Data Transfer Cable
Connects your PC to the GP, allowing
screen data to be transferred between
the two.
Tool Connector
Memory Loader II
(GP070-LD01-O)
Copies data at high speed from one GP to
another.
(Both system program and screen data)
RS-232C Cable
(GP410-IS00-O)*3
RS-422 Cable
(GP230-IS11-O)
I/F cable to connect GP to the Host (PLC).
Multi-link Cable
(GP230-IS12-O)
Allows multi-link
(n:1)
SIO between the
Host (PLC) and the GP. Standard RS-422
interface cable.
RS-422 Terminal Adapter
(GP070-CN10-O)
Adapter for converting output from a serial
interface to RS-422 I/F.
Mitsubishi A Series
Programming Port I/F cable
(GP430-IP10-O)
Mitsubishi PLC FX Series
Programming Port I/F Cable
(GP430-IP11-O)
Connects directly to Mitsubishi's FX Series
I/F Programming Console. Conversion link
unit not necessary. Simultaneous use of
program console, however, is not possible.
Mitsubishi PLC A, QnA, C, FX
Series
2 Port Adapter
(GP030-MD11)
Interface unit that allows use of both GP
and Mitsubishi A, QnA, C, FX series
equipment in the same location.
2 Port Adapter II
(GP070-MD11)
Interface unit that allows simultaneous use
of GP series units and Mitsubishi A, QnA,
C, FX series peripherals.
2 Port Adapter II Cable
(GP070-MDCB11)
Cable to connect 2 Port Adapter II with
Mitsubishi A, QnA, C, FX series units.
Serial Interface
Cables/Units
Siemens Simatic Series
Current Loop Converter Cable
(GP000-IS11-O)
TTY converter cable for Siemens Simatic
S5 Series PLCs. Simultaneous use of
program console is not possible.
1.3 Optional Equipment
*3 For detailed information about range of connectable PLCs.
PLC Connection Manual.
*1 Use GP-PRO/PBIII for Windows Ver. 2.1 or higher.
*2 GPW-CB-SET can also be used.
Reference