User manual

Chapter 3 - Installation and Wiring
GP-2400/2500/2600 Series User Manual
3-10
3.3 Tool Connector
The GP’s Data Transfer Cable can be attached to the GP unit’s Tool Connector.
Bottom Face
GP-2500 Series, GP-2600 Series
Ethernet Interface
(RJ-45 Connector)
Tool Connector
Bottom Face
GP-2500 Series, GP-2600 Series
3.4 Ethernet Cable Connector
Use the following drawing to locate your GP unit’s Ethernet connector. The GP
Ethernet interface is IEEE802.3 compliant, and transmits data at 10Mbps.
• It is strongly recommended that your Ethernet network is installed by a trained
engineer.
• You may not be able to use the 1:1 connection by a cross cable depending on PCs or
network cards. Be sure to connect those with a hub.
WARNING
To prevent an electric shock, unplug the GP unit’s power
cord from the main power supply prior to attaching or de-
taching any connector(s) to or from the GP.
Rear Face
GP-2400 Series
Side Face
GP-2400 Series