Specifications

49/51

Chapter 5 Appendix

5.1 Changing the setting of the external media to use

If a CF card has been used for GP-PRO/PBIII, after GP-2500 series is replaced with

GP-4501TW with GP-Pro EX, “a CF card” is automatically replaced with “a SD card” for

the external media setting.

(1) After conversion of the project file data, at GP-Pro EX Error Check, if the message,

“The project contains features that require a SD card. However, the selected display

does not support SD cards so these features will not run.” appears,

<Cause>

The model without a SD card slot has the setting that uses a SD card.

->Solution 1

(2) To use a USB storage device instead of a SD card ->Solution 1

(3) To check or change the SD card’s data output destination folder setting

->Solution 2

[Solution]

1. Change the SD Card setting to the USB storage setting following the steps below.

i. Click [Project]->[Information]->[Destination Folder].

ii. Uncheck “Enable SD Card” and check “Enable USB Storage.