Installation and Operating Instructions

8
If such defects should occur, this unit will either be repaired or replaced at the discretion of the manufacturer. It is the
responsibility of the original purchaser to return the charger along with proof of purchase, transportation, and/or any mailing
or handling charges prepaid to the manufacturer or its authorized representative. Chargers that are purchased more than
two years beyond the date of production will automatically have a warranty start date that will be the two year anniversary of
the production date.
This limited warranty is void if the product is misused, improperly maintained, handled carelessly or incorrectly operated.
Additionally, this warranty is void if the charger is disassembled, the charger’s charge cables are cut, the power cord is cu
t
off, the charger is altered without authorization from PCS, the serial number is removed, or repair is attempted by anyone
other than an authorized representative. PCS makes no other warranty other than this limited warranty and expressly
excludes any implied warranty, including warranty for any incidental or consequential damages. This is the only expressed
limited three year warranty authorized by PCS and does not authorize anyone to assume or make any other obligation
towards the product other than this three year Limited Warranty. Some states do not allow limitation of incidental or
consequential damages.
This warranty gives you specific legal rights and you may also have other rights which vary from state to state. Please call
Pro Charging Systems, LLC for full warranty information and/or service please call (
615.471.5300).
FCC Compliance Statement
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) this device must accept any interference received, including interference that may
cause undesired operation.
CAUTION: The grantee is not responsible for any changes or modifications not expressly approved by the party responsible
for compliance. Such modifications could void the user’s authority to operate the equipment.
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of
the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential
installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in
accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee
that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or
television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct t
he
interference by one or more of the following measures:
– Reorient or relocate the receiving antenna.
– Increase the separation between the equipment and receiver.
– Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
– Consult the dealer or an experienced radio/TV technician for help.
This equipment has been tested and meets applicable limits for radio frequency (RF) exposure. This transmitter must not be
co-located or operating in conjunction with any other antenna or transmitter.
RF Exposure Statement
This equipment complies with the FCC RF radiation exposure limits set forth for an uncontrolled environment. This equipment
should be installed and operated with a minimum distance of 20cm between the radiator and any part of your body.