Safety, Installation and Operating Instructions Instructions importantes concernant la sécurité 072318-70251 IMPORTANT NOTICE: Please save and read these safety, operating and installation instructions before installing or applying AC power to your Pro Charging Systems (PCS) charger. Contact technical support at PCS with any product, installation, or service questions (615.471.5300).
TABLE OF CONTENTS Important Safety Instructions……………………………………………………. Pages 2-3 Installation and Preparation ………………………………………………………Page 4 General Operation …………………………………………………………………Pages 4-5 Charging Indications……………………………………………………………….Page 6 Troubleshooting ……………………………………………………………………Page 6 LED Fault Code Indications ……………………………………………………..Page 7 Limited Warranty Information……………………………………………………..Page 7 Additional Products………………………………………………………………..
4. Stay alert. Watch what you are doing, and use common sense. Do not operate any charger when you are tired. 5. Keep children away. Children must never be allowed in the work area. Do not let them handle machines, tools, battery chargers, or extension cords. 6. Keep work area clean. Cluttered areas invite injuries. 7. Observe work area conditions. NEVER smoke or allow a spark or flame in the vicinity of battery or engine. Don’t expose to rain. Keep work area well lit. 8. Do not overreach.
Do not operate charger in a closed-in area or restrict ventilation in any way. Ne pas faire fonctionner le chargeur dans un espace close et/ou ne pas gener la ventilation. Clean battery terminals. Be careful to keep corrosion from coming into contact with eyes. Add distilled water to each cell until battery acid reaches level specified by battery manufacturer. This helps purge excessive gas from cells. Do not overfill. For a battery without cell caps, carefully follow manufacturer’s recharging instructions.
DO NOT connect or disconnect the DC output electrical cord to or from the battery receptacle when the charger is on. Arcing and / or burning of the plug and receptacle could result and could cause the batteries to explode. If the charger must be stopped, first disconnect the AC power supply cord from its outlet, then disconnect the charger DC output plug from the battery receptacle. We recommend that you leave your system plugged in.
CHARGING INDICATIONS When your battery charging system is activated, the battery status indicator provides charging information utilizing three red LED indicators, two amber LED indicators, and one green LED indicator. Battery Type Indicators Two amber LED indicators are provided in order to display what type of battery the charger has been programmed to charge. NOTE: For information on reconfiguring the battery type, please contact technical support (615.471.5300).
Solution Sequence: 1. Disconnect AC power from the charging system. This indication may signify a possible battery problem. 2. Call technical support for further assistance (615.471.5300). PROBLEM: A green LED was illuminated before disconnecting the power from the charger, but upon reconnection, red LEDs appear and remain on. This is the normal operating procedure for the system. It indicates that a reanalysis of the battery status was initiated and after a series of steps the green LED will illuminate.
If such defects should occur, this unit will either be repaired or replaced at the discretion of the manufacturer. It is the responsibility of the original purchaser to return the charger along with proof of purchase, transportation, and/or any mailing or handling charges prepaid to the manufacturer or its authorized representative.
