Miss LLumar 1/12-Scale RTR Nitro Unlimited Hydroplane Owner’s Manual Specifications Overall Length ............................................................................................ 27.5 in (698.5mm) Beam .............................................................................................................. 14 in (355.6mm) Engine ................................................................................................ DYN .15 Marine w/Recoil Radio System ............................
Table of Contents Introduction ...................................................................................................................................................................................................................... 2 Warning ............................................................................................................................................................................................................................ 2 Additional Required Items .......
Additional Required Items Although the Miss LLumar comes fully assembled and ready for action, you will need a few tools to get your boat ready to run: Blue Thunder 20% Fuel (quart) (DYN2320) 500cc Fuel Bottle (DYN2003) or Fast Tap Quart Bottle Spout (DYN2009) Glow Plug Wrench (DYN2510) Ni-Cd Glow Driver (DYN1925) 12 “AA” alkaline batteries (8 for the transmitter and 4 for the receiver) Clear 3M tape to seal radio box Suggested Field Equipment and Supplies In addition to the items needed to run the Miss LL
Section 1: Installation of Receiver and Transmitter Batteries Receiver Batteries 4 1 Remove the clear lid that covers the radio box. Remove the two knurled aluminum nuts that secure the cockpit as shown. Pull the cockpit off the boat. Carefully note how the exhaust system is assembled. 2 5A Use a 2.5mm Allen wrench to remove the tuned pipe mount as shown above.
Section 1: Installation of Receiver and Transmitter Batteries (cont.) 8B 8A 6A Re-install the tuned pipe mount. 6B Transmitter Batteries Remove the transmitter from the box. 9A 9B Re-install the battery holder back into the radio box and properly seal the radio box with clear tape. Failure to properly seal the radio box could result in damage to your radio equipment. 9C 7 Remove the battery cover on the bottom of the transmitter.
Section 2: Turn Fin The Miss LLumar comes with the turn fin installed on the right sponson. You will want you run the Miss LLumar in an oval and in an area that will allow you to make right turns (clockwise). Do not attempt to make tight left hand turns (counterclockwise), or you could easily flip the boat. If you need to make a left turn, do so in a large diameter turn at slow speeds.
Section 5: The Dynamite .15 Marine Engine (cont.) You may have to "blip" the throttle on the transmitter (applying throttle on/off) while trying to start the engine. New engines are harder to start because of the tight piston/sleeve fit. Never start an engine at 1⁄2 to full throttle, as this will cause over-revving which may cause premature wear and breakage. Note: It is common for an ABC engine to go through a glow plug or two during break-in.
Troubleshooting Guide (cont.) The Pro Boat™ Miss LLumar should provide many hours of exciting high-speed racing fun with just minor maintenance. Preventative maintenance is very important. Taking the time to ensure that all the set screws and bolts are tight before each operation of the boat will prevent many problems. When refueling, always wipe away any excess fuel that may have spilled into or on the boat. After operating the Miss LLumar Wipe off any exhaust residue from the boat.
Section 6: Maintenance (cont.) 3 5B Liberally lubricate the entire length of the flex shaft with silicone cable grease as shown. Loosen the 2 manifold bolts with your 2.5mm Allen wrench. Next insert your Allen driver into the hole located on the flywheel to lock the crankshaft in place. Then use an 11mm wrench to loosen the collet nut. 6A 4 6B Carefully pull the ferrule away from the stuffing tube. You will need to pull at an angle to clear the aluminum strut.
Section 7: Miss LLumar Replacement Parts In the event that you need to purchase replacement parts for your engine or the Miss LLumar, please see your local hobby store. You can also purchase them from Horizon Hobby by calling 1-800-338-4639 or shop online @ www.horizonhobby.
Look for these other fine Pro Boat™ models at your local hobby dealer. • Professionally painted and detailed fiberglass hull • Speeds up to 30 mph • Water-cooled Dynamite® .15 marine nitro engine • JR® Python pistol-grip radio system installed • Length: 27.
Notes MADE IN CHINA © 2004 Horizon Hobby, Inc. www.horizonhobby.
