User Manual

ManualsBrandsPro Boat ManualsWater equipmentPRB2200 V.2

Specifications

Overall Length ............................................................................................ 27.5 in (698.5 mm)

Beam ............................................................................................................ 14 in (355.6 mm)

Engine................................................................................................ DYN .15 Marine w/Recoil

Radio System ........................................................................................ JR AM 75MHz Python

Owner’s Manual

1/12-Scale RTR Nitro Unlimited Hydroplane

Summary of content (12 pages)

PAGE 1
/12-Scale RTR Nitro Unlimited Hydroplane Owner’s Manual Specifications Overall Length ............................................................................................ 27.5 in (698.5 mm) Beam ............................................................................................................ 14 in (355.6 mm) Engine ................................................................................................ DYN .15 Marine w/Recoil Radio System ........................................
PAGE 2
Table of Contents Introduction ...................................................................................................................................................................................................................... 2 Warning ............................................................................................................................................................................................................................ 2 Additional Required Items .......
PAGE 3
Additional Required Items Although the Miss Budweiser comes fully assembled and ready for action, you will need a few tools to get you ready to run your boat.
PAGE 4
Section 1: Installation of Receiver and Transmitter Batteries Receiver Batteries 4 1 Remove the two knurled aluminum nuts that secure the cockpit as shown. Pull the cockpit off of the boat. Remove the clear lid that covers the radio box. Carefully note how the exhaust system is assembled. 2 5A Use a Phillips screw driver to remove the tuned pipe mount as shown above.
PAGE 5
Section 1: Installation of Receiver and Transmitter Batteries (cont.) 8B 8A 6A Re-install the tuned pipe mount. 6B Transmitter Batteries Remove the transmitter from the box. 9B 9A Re-install the battery holder back into the radio box and properly seal the radio box with clear (3M) tape. Failure to properly seal the radio box could result in damage to your radio equipment. 9C 7 Remove the battery cover on the bottom of transmitter.
PAGE 6
Section 2: Turn Fin The Miss Budweiser comes with the turn fin installed on the right sponson. You will want you run the Miss Budweiser in an oval and in an area that will allow you to make right turns (clockwise). Do not attempt to make tight left hand turns (counterclockwise), or you could easily flip the boat. If you need to make a left turn, do so in a large diameter turn at slow speeds.
PAGE 7
Section 5: The Dynamite .15 Marine Engine Water-Cooled Engine Because the Dynamite® 15S engine is water-cooled and not air cooled, make sure that you do not run the engine for an extended amount of time outside of the water. Continuously monitor the water outlet when the boat is running to make sure that the water is reaching the engine head. If the water does not reach the head to cool it, the engine will overheat and fail. This could cause permanent damage to the engine.
PAGE 8
Troubleshooting Guide Problem Possible Solution Engine will not start Check needles and make changes back to factory settings if necessary Improper needle setting Out of fuel Improper fuel Improper glow plug Glow igniter not charged Dead glow plug Flooded engine Engine starts, then dies Pressure line blocked or unhooked Reset needles to baseline setting Improper needle settings Engine starts and runs for several minutes, then dies Bad glow plug Idle speed set too low Improper needle settings Overheat
PAGE 9
Section 6: Maintenance (cont.) Lubrication It is important to lubricate the drive shaft of the Miss Budweiser with silicone cable grease after every two hours of operation. Do not forget to do this. You can purchase this silicone grease at your local hobby store. To lubricate the drive shaft, follow these simple instructions. 1A 3 Flywheel Drive Dog 1.5 mm Set Screw Loosen (do not remove) the 1.5 mm set screw with a 1.5 mm hex driver or Allen wrench from the drive dog. 1B 4 Prop Drive Dog 1.
PAGE 10
Section 6: Maintenance (cont.) 6B 5B Liberally lubricate the entire length of the drive shaft with silicone cable grease as shown. 6C 6A Carefully re-install the drive shaft, making certain that you correctly tighten both set screws on the flats of the drive shaft. Next, re-install the propeller and tighten prop nut as shown. Section 7: Replacement Parts In the event that you need to purchase replacement parts for your engine or the Miss Budweiser, please see your local hobby store.
PAGE 11
Appendix Photo 1 Fuel Tank Photo 2 Pull Starter Water-Cooling Line Water-Cooling Line Water-Cooled Head Rubber Boot Carburetor Coupler Rudder Exhaust Manifold Fuel Line Water Intake for Cooling Glow Plug Photo 3 Photo 4 Turn Fin 2.