Manual

Owner’s Manual

Vehicle Starting and Running

Breaking in the Engine

CAUTION: Makesureyouunderstandallengineinstructionsbeforeattemptingtostarttheengine.

Failuretofollowallinstructionscanleadtodamagetoyourvehicle,propertydamageandbodilyinjury.

CAUTION:Alwayskeepallbodyparts,hairanddanglingorlooseitemsawayfromaspinningpropeller,asthese

couldbecomeentangled.

1. Removethecanopy.

2. Poweronyourtransmitter,thenpoweronthe

receiver.

3. Presstheprimingbulbseveraltimesuntilitbecomes

lledwithfuel.Thisisnotnecessaryiftheenginehas

beenrunrecently.

4. Withtheboatonastandandthepropellerunobstructed,

pullthestartercordinaquickcontinuousmotiontostart

theengine.Theengineshouldstartwithin6pulls.

5. Replacethecanopybeforeplacingtheboatinthe

water.

Breakintheenginebyrunningslowlyforthefirsthalf

tankoffuel(about25minutes).

NOTICE: Donotadjustcarburetorsettingsduring

break-in.Doingsowillcauseenginedamage.

Whentheboatismovingforward,ensurewaterflows

outofthecoolantoutlets.Ifwaterisnotflowingoutof

thecoolantoutlets,removeanyblockagefromtherudder

inletandcoolantsystemortheengineandtunedmuffler

mayoverheat.