Manual

Owner’s Manual
Receiver Battery Installation
1. Removethe2clipsandlidfromthebattery
compartment.
2. Installthebatteryinthebatterycompartment.
3. ConnectthebatteryEC3™connectortotheON/OFF
switch.
4. Installthelidontheboxandsecurethelidusingthe
clips.
IMPORTANT:Afterboating,alwaysremovethebattery
beforetransportingorstoringtheboat.
Antenna Tube Installation
1. Removethe3clipsand2lidsfromtheboxes.
2. Removethesetscrewusinga1.5mmhexdriverand
theantennatubefromthesideoftheradiobox.
3. Feedtheantennathroughtheantennamountandinto
theantennatubeasshown.
4. Installthetubeintheantennamount,thensecurethe
tubewitha3mmsetscrewusinga1.5mmhexdriver.
5. Replacethelidsandclipsontheboxes.
6. Guidetheantennatubethroughtheholeinthe
canopyandinstallthecapontheantennatube.
IMPORTANT:Theantennamustbeinstalledabove
theboat’swaterlinetogetthebestreceptionofyour
transmitter’ssignal.
Charging the Receiver Battery
Instructions
Chooseachargerdesignedtochargetheincluded7.4V
5200mAh2S15CLiPo.WerecommendtheDynamite
®

ProphetSportLiPoACBalanceCharger(DYNC2005).
Refertoyourchargermanualforcharginginstructions
andsafetyinformation.
NOTICE:Neverchargeabatteryintheboator
damagemayresult.
5
EN