Manual

48
Rudder Installation
1. Installtherudderinthemountusing2screwsand2
locknutsasshown.
2.Connectthetubefromthebackoftheboattothe
barbedfittingonthetopoftherudder.
Propeller Installation
1. Correctlyalignthepropellerwiththedrivedogonthe
propshaft.
2. Tightenthenutonthepropshaft.
3. Disassembleinreverseorder.
Tip:Propellerbalancingcanaddseveralmphtotop
speedandreducevibration.Thereareseveraldifferent
propellerbalancingtoolsavailable.Readtheinstructions
thataccompanythepropellerbalancingtool,asremoving
materialfromthecorrectpartofthepropelleriscrucial.
Boat Stand Assembly
1. Attachthesidestandpiecestotheendpiecesas
shown.
2. UsemediumCAorepoxyadhesivetosecuretheside
standtotheends.
3. Allowtheadhesivetodrybeforeplacingyourboaton
thestand.
Canopy Removal
1. Pushdownandturnthe2knurledpinsonequarterof
aturntodisengagethepinsfromthehull.
2. Carefullylifttherearofthecanopyandpullbackto
disengagethefrontpinfromthehull.
4
EN
