Manual

Owner’s Manual
Spark Plug Test
CAUTION: Beforetestingthesparkplug,cleanup
spilledfuelandclosefuelcontainers.Failuretodo
canresultininjury,fireordamage.
Removethesparkplugfromtheengineandattachthe
plugwireandboottothesparkplug.Placethethreaded
endofthesparkplugagainstthemuffler.Pullthestarter
cordinaquickcontinuousmotiontoturnovertheengine
andensurethereisaspark.
Ifthereisnospark:
• Adjustthesparkpluggapto0.6–0.7mm(0.24–0.27in)
• Installanewsparkplug(LOSR5017)
CAUTION: Donottestthesparkplugnearthe
sparkplugholeorresidualfuelmayignite.
Flooded Engine
Theenginewillnotstartiftoomuchfuelisinthe
cylinder.Excessfuelcanbeexpelledbyfollowingthe
stepsbelow.
1. Disconnectandremovethesparkplug.
2. Pullthestartercordinaquickcontinuousmotion.
3. Replacethesparkplugandmakesurethebootis
tightlysecured.
NOTICE:Alwayscleanupspilledfuel.Failuretodoso
mayresultininjuryordamage.
0.6–0.7mm
0.24–0.27 in
0.6–0.7mm
0.24–0.27 in
0.6–0.7mm
0.24–0.27 in
0.6–0.7mm
0.24–0.27 in
13
EN