PRB08041 Recoil 2 26-inch - Manual

Instruction Manual
A. Steering Wheel Controls direction (left/right) of the model
B. Throttle Trigger Controls speed and direction (forward/brake/
reverse) of the model
C. LED Controls the lights On/Off (if equipped)
D. ON/OFF Switch Turns the power ON/OFF
E. Indicator Light
• Solid red lights—Indicates radio connectivity and adequate
battery power
• Flashing red lights—Indicates the battery voltage is critically
low. Replace batteries
F. CH 3 Activates Self-Righting Feature
G. TH Reverse Reverses the function of the speed control when
pulled back or pushed forward
H. ST Reverse Reverses the function of the steering when the wheel
is turned left or right
I. ST Rate Adjusts the steering rate switch
J. ST Trim Adjusts the steering center point
K. TH Rate Adjusts the throttle limit switch
L. TH Trim Adjusts the throttle neutral point
Transmitter Battery Installation
This transmitter requires 4 AA batteries (Not Included).
1. Remove the battery cover from the transmitter.
2. Install the batteries as shown.
3. Install the battery cover.
CAUTION: Never remove the transmitter batteries while the
model is powered ON. Loss of model control, damage, or
injury may occur.
CAUTION: If using rechargeable batteries, charge only
rechargeable batteries. Charging non-rechargeable batteries
may cause the batteries to burst, resulting in injury to persons and/
or damage to property.
CAUTION: Risk of explosion if battery is replaced by an incor-
rect type. Dispose of used batteries according to national
regulations.
OFF ON
ST
TH
D/R TRIM D/R TRIM
ST TH
0
1
2
3
4
1
2
3
4
0
1
2
3
4
1
2
3
4
MIN MAX
2
3
4
5
6
MIN MAX
2
3
4
5
6
OFF ON
N
R
ST
2.4GHz
N
R
ST
N
R
TH
OFF ON
ST
TH
D/R TRIM D/R TRIM
ST TH
0
1
2
3
4
1
2
3
4
0
1
2
3
4
1
2
3
4
MIN MAX
2
3
4
5
6
MIN MAX
2
3
4
5
6
OFF ON
N
R
ST
2.4GHz
N
R
ST
N
R
TH
A
B
C
E
G
H
I
J
K
L
D
F
59107.1 Harbor Tug
Transmitter Functions
5
EN
Install the receiver antenna in the tube as shown. Do not bend end of
antenna over antenna tube and place cap over it. The antenna does
not have to be outside of the tube to operate properly.
Keep the end of the antenna above the boat’s waterline to get the
best transmitter reception. Apply clear tape (DYNM0102), if desired.
NOTICE: Do not cut or kink the receiver antenna or damage may
result.
Antenna Tube Installation