PRB08041 Recoil 2 26-inch - Manual

Instruction Manual
Troubleshooting Guide
Problem Possible Cause Solution
Boat will not respond to
throttle but responds to
other controls
Throttle channel is reversed Reverse throttle channel on transmitter
Extra noise or extra vibration
Damaged propeller, shaft or motor Replace damaged parts
Propeller is out of balance Balance or replace propeller
Reduced runtime or boat
underpowered
Boat battery charge is low Completely recharge battery
Boat battery is damaged Replace boat battery and follow battery instructions
Blocking or friction on shaft or propeller Disassemble, lubricate and correctly align parts
Boat conditions may be too cold Make sure the battery is warm (above 10º C [50º F]) before use
Battery capacity may be too low for conditions Replace battery or use a larger capacity battery
Drive dog is too near the stuffing tube
Loosen drive shaft side of the motor coupling and move drive
shaft small amount back
Too little lubricant on drive shaft Fully lubricate drive shaft
Vegetation or other obstacles block the rudder or
propeller
Remove vegetation or obstacles from rudder or propeller
Boat will not Bind (during
binding) to transmitter
Transmitter is too near boat during binding process
Move powered transmitter a few feet from boat, disconnect
and reconnect battery to boat
Boat or transmitter is too close to large metal object,
wireless source or another transmitter
Move the boat and transmitter to another location and
attempt binding again
Another compatible transmitter is powered on within
range of the receiver
Power off all compatible transmitters except the one you are
trying to bind
Boat battery/Transmitter battery charge is too low Replace/recharge batteries
ESC switch is off Power on ESC switch
Boat will not connect (after
binding) to transmitter
Transmitter is too near boat during connecting
process
Move powered transmitter a few feet from boat, disconnect
and reconnect battery to boat
Boat or transmitter is too close to large metal object,
wireless source or another transmitter
Move boat or transmitter to another location and attempt to
connect again
Boat battery/transmitter battery charge is too low Replace/recharge batteries
ESC switch is off Power on ESC switch
Boat tends to dive in the
water or takes on water
The boat hull is not completely closed
Dry out the boat and ensure the hatch is fully closed on the
hull before returning the boat to the water
Center of gravity is too far forward Move batteries back in the hull
Trim tabs are angled incorrectly
Angle each trim tab up a small amount to lift the
bow or down a small amount to lower the bow
Boat tends to turn one
direction
Rudder or rudder trim is not centered
Repair rudder or adjust rudder and rudder trim for straight
running when control is at neutral
Vertical fins are angled incorrectly
Adjust the right or left fin angle for straight
running when control is at neutral
Rudder does not move
Rudder, linkage or servo damage Replace or repair damaged parts and adjust controls
Steering servo wire is damaged or connections are
loose
Do a check of steering servo wires and connections, connect
or replace as needed
Transmitter is not bound correctly Re-bind
BEC (Battery Elimination Circuit) of the ESC is
damaged
Replace ESC
ESC switch is off Power on ESC switch
Controls reversed Transmitter settings are reversed
Perform the Control Direction Test and adjust controls on
transmitter appropriately
Motor overheats Blocked water cooler tubes Clean or replace water tubes
Motor power pulses then
motor loses power
Weather conditions might be too cold Postpone until weather is warmer
Battery is old, worn out or damaged Replace battery
11
EN