Horizon Harbor 30-Inch Tug Boat RTR Manual

Horizon Harbor 30-Inch Tug Boat

Boat Stand Assembly

1. Attach the side stand pieces to the end pieces

as shown.

2. Use medium CA or epoxy adhesive to secure

the side stand to the ends.

3. Remove the self adhesive backing from the foam

padding, and install it around the boat cradles.

4. Allow the adhesive to dry before placing

the boat on the stand.

1. Bow Hatch: Carefully lift the bridge canopy and bridge

assembly to access the receiver/ESC, battery, motor,

and water cannon hoses. The cover magnetically

attaches to the hull.

2. Middle Hatch: Carefully lift the large wrench hatch

to access the steering servo. The cover magnetically

attaches to the hull.

3. Rear Hatch: Carefully lift the cover to access the

steering bellcrank. The cover magnetically attaches

to the hull.

Hatch Removal

Tip: You can use wood glue

instead of CA, but it requires

a longer drying time.

• Needle nose pliers

• Paper towel

• Rubbing alcohol

• Phillips screwdriver: #1

• Hex wrench: 1.5mm, 2mm, 2.5mm, 3mm

• Clear tape (DYNM0102)

• Pro Boat

Marine Grease and Gun

• Hook and Loop Tape Set, WP 4pcs

Recommended Tools and Materials