Horizon Harbor 30-Inch Tug Boat RTR Manual

Instruction Manual
General Precautions
• Read the WET CONDITIONS MAINTENANCE
procedures and make sure that you have all the tools
you will need to properly maintain your boat.
• Not all batteries can be used in wet conditions.
Consult the battery manufacturer before use.
Caution should be taken when using Li-Po batteries
in wet conditions.
• Most transmitters are not water-resistant. Consult
your transmitter’s manual or the manufacturer
before operation.
• Never operate your transmitter or boat when
lightning is present.
• Salt water is very conductive and highly corrosive.
If you choose to run your boat in salt water,
immediately rinse the boat in fresh water after each
use. Operating your boat in salt water is at the sole
discretion of the modeler.
Wet Conditions Maintenance
• Drain any water that has collected in the hull
by removing canopy and tilting the boat in the
appropriate direction to drain the water.
CAUTION: Always keep hands, fingers, tools and any
loose or hanging objects away from rotating parts.
• Remove the battery pack(s) and dry the contacts. If
you have an air compressor or a can of compressed
air, blow out any water that may be inside the
recessed connector housings.
• Remove all moving parts. Dry and lubricate parts
after every 30 minutes of operation or if the boat
becomes submerged.
NOTICE: Never use a pressure washer to clean your boat.
• Use an air compressor or a can of compressed air
to dry the boat and help remove any water that may
have gotten into small crevices or corners.
• Spray the bearings, fasteners and other metal parts
with a water-displacing light oil or lubricant.
• Let the boat air dry before you store it. Water (and
oil) may continue to drip for a few hours.
Table of Contents
Water-Resistant Boat with Waterproof Electronics ............................. 2
General Precautions ........................................................................... 3
Wet Conditions Maintenance ............................................................ 3
Specifications......................................................................................... 3
Product Inspection ................................................................................. 3
Recommended Tools and Materials ...................................................... 4
Boat Stand Assembly ............................................................................. 4
Hatch Removal ....................................................................................... 4
Battery and Charger ............................................................................... 5
Low Voltage Cutoff (LVC) ....................................................................... 5
Battery Installation ................................................................................ 5
Transmitter Functions............................................................................. 6
Transmitter Battery Installation ........................................................... 6
Binding ................................................................................................... 7
Failsafe ................................................................................................... 7
Retrieval Arms ....................................................................................... 7
Optional Water Cannon Pump ............................................................... 7
Getting Started ...................................................................................... 8
Range Check .......................................................................................... 8
Testing Your Boat in the Water ............................................................. 8
Product Inspection
Carefully remove the boat and radio transmitter from the box.
Inspect the boat for damage. If your product is damaged,
please contact the hobby shop where you purchased your
boat, or contact Product Support. Refer to the Warranty and
Service Contact Information section for more info.
Boating Tips ........................................................................................... 9
Motor Care ............................................................................................. 9
When You Are Finished ......................................................................... 9
Drive Shaft Maintenance ..................................................................... 10
Troubleshooting Guide ......................................................................... 11
Limited Warranty ................................................................................. 12
Warranty and Service Contact Information ......................................... 13
FCC Information ................................................................................... 13
IC Information ...................................................................................... 13
Compliance Information for the European Union ................................ 13
Instructions for Disposal of WEEE ....................................................... 13
Replacement Parts ............................................................................... 50
Recommended Parts ............................................................................ 50
Optional Parts ...................................................................................... 50
Specifications
Length 30 in (762mm)
Beam 8.75 in (222mm)
Transmitter Horizon Multi Model LT
(HRZ00010)
Receiver/ESC 2-in-1 40A Brushed ESC/LT
(HRZ00011)
Hull Material ABS
Motor Brushed 700 (PRB282088)
Servo Spektrum™ S603 (SPMS603)
Batteries Transmitter: 4 AA (sold
separately)
Boat: 3S 5000mAh 20-50C with
EC5/IC5 connector (sold
separately)
30 in (762 mm)
8.75 in
(222mm)
3
EN