User Manual

Instruction Manual
During the first run, we recommend calm wind and water
conditions to ensure that the boat is properly set up.
Maximum speeds of 50 MPH/+ can be achieved once you
have set up the boat for your specific conditions. Top speed
will also be determined by the battery’s ability to efficiently
deliver power to the motor via the ESC.
Consult local laws and ordinances before choosing a location
to pilot your boat.
1. Carefully place the boat in the water.
2. Operate the boat at slow speeds near the shoreline. Avoid
objects in the water at all times. When the boat is moving
forward, ensure water flows out of the coolant outlet.
3. Once you are comfortable operating the boat at slow
speeds, it is safe to operate the boat farther from the
shore at higher speeds.
4. Bring the boat back to shore when the motor starts to pulse.
NOTICE: Never operate your boat in less than 12 inches
(30.5 cm) of water.
CAUTION: Never attempt to retrieve a downed boat
by swimming. If you need to retrieve your boat from
the water, use fishing equipment or another boat.
NOTICE: When running at full speed in choppy water, the
propeller may exit and re-enter the water repeatedly and very
quickly, subjecting the propeller and drive shaft to some stress.
Frequent stress may damage the propeller and drive shaft.
In rough water and windy conditions, consider:
• mounting the batteries further forward for added stability
• adjusting the struts downward to prevent the boat from
overturning
Avoid boating near:
• watercraft
• people (swimming areas, fishing areas)
• stationary objects
• waves and wakes
• rapidly moving water
• wildlife
• floating debris
• overhanging trees
• vegetation
Boating Tips
Self-Righting
The self-righting feature uses a water ballast system. The
ballast works as a controlled breach in the hull. As the
ballast fills with water, the weight of the water forces the
boat to sink, while the air trapped inside the hull causes
enough buoyancy to right the boat.
The boat will self-right automatically, using water ballast.
Once the boat is upright, it will lean to one side. Apply full
throttle. The trapped water will be forced out of the ballast
tanks by the boat’s forward momentum.
IMPORTANT: Applying throttle during the self-righting
process may prevent the boat from turning over.
Propeller Service
1. Use an 8mm nut driver to loosen the nut (A) from the
driveshaft (B).
2. Remove the nut and propeller (C) from the driveshaft.
3. Inspect the propeller for any damage or wear and replace
as necessary.
4. Assemble in reverse order. Correctly align the propeller
with the drive dog on the driveshaft.
7
EN
Maintenance
BB
AA
CC