Veles 29" Catamaran Manual

1. Loosen the 4 screws located at each corner of the

canopy.

2. Remove the canopy from the hull starting with the 2

rear screws. Ensure that the 4 screws have disengaged

from their bases before carefully lifting the canopy.

Installing the Battery Packs

The included electronics are rated for 2S–6S LiPo

batteries; however, running the stock propeller

nonstop on a 6S battery could overheat your

electronics or damage your batteries. If you run the

stock propeller on 6S, we recommend using full

throttle on straight line passes only. Return passes

should be at half throttle to reduce the heat of the

electronics. If you want to run 6S nonstop, use

optional propellers (PRB282006 or PRB282027).

1. Install the 2 battery packs on the left and right

sides of the boat hull. Secure the batteries with

the included hook and loop straps. When running

your boat in rough water, use Waterproof Hook

and Loop Tape (DYNK0300) between the batteries

and the battery tray to secure the batteries more

fully.

Tip: Place the batteries as far back in the battery

trays as possible to achieve maximum speed and

handling. If water and wind conditions are too

strong, stabilize the boat by moving the battery

packs forward 1/4 inch at a time.

2. Connect each battery pack to the ESC power

connectors.

The included propeller provides the best performance

between 4S (14.8V) and 5S LiPo (18.5v). 5S

configuration can be achieved by mounting a 3S

LiPo (DYNB3811EC) on the left side of the boat and

a 2S, LiPo (DYNB3810EC) on the right side of the boat.

The added weight of the 3S battery on the left side will

counteract torque twist caused by the propeller spinning

at high RPM.

WARNING: When using 2 batteries in series, always

make sure they are in roughly the same condition

(age) and they have the same capacity (mAh) and

discharge rate (C rating). Failure to do so may cause

damage to your batteries, potentially causing a fire.

Canopy Removal

29-INCH READY-TO-RUN BRUSHLESS CATAMARAN