User Manual

Antenna Tube Installation
1. Carefully feed the end of the receiver antenna through the grommet inside the
hull.
2. Pull the antenna wire out of the grommet toward the outside of the boat, then
slide the antenna through the antenna tube.
3. Insert the tube into the grommet, then fi t the cap onto the tube.
4. Slide the clear 20mm waterproof sleeve over the grommet and hull and install
the tube into the sleeve.
The antenna must be installed above the boat's waterline to get the best
reception of your transmitter's signal.
NOTICE: Do not cut or kink the receiver antenna or damage may result.
Boat Stand Assembly
1. Attach the side stand pieces to the end pieces as
shown.
2. Use medium CA or epoxy adhesive to secure the side
stand to the ends.
3. Allow the adhesive to dry before placing your boat on
the stand.
4
EN
UL 19 Hydroplane
Product Inspection
Carefully remove the boat and radio transmitter from the box.
Inspect the boat for damage. If your product is damaged, please
contact the hobby shop where you purchased your boat, or
contact Horizon Hobby Product Support. Refer to the Warranty
and Service Contact Information section for more info.
Recommended Tools and Materials
• Needle nose pliers
• Paper towel
• Rubbing alcohol
• Open-end wrench: 10mm (2)
• Nut driver: 4mm, 7mm, 8mm
• Phillips screwdriver: #1
• Hex wrench: 1.5mm, 2mm, 2.5mm, 3mm
• Clear tape (DYNM0102)
• Pro Boat
®
Marine Grease and Gun (DYNE4200)
• Hook and Loop Tape Set, WP 4pcs (DYNK0300)