User Manual

Drivetrain Lubrication
Always replace the drivetrain parts when they are
damaged or show visible wear or injury and damage may
result.
Lubricating the flex shaft is vital to the life of the
drivetrain. The lubricant also acts as a water seal, keeping
water from entering the hull through the stuffing tube.
Lubricate the flex shaft and propeller strut after every 30
minutes of operation and/or everytime you change the
batteries.
1. Inside the hull, use 2 10mm open-end wrenches to
loosen the collet nut from the fl ex shaft.
2. Slide the fl ex shaft out from the stuffi ng tube and
drive strut at the rear of the boat.
Tip: Use paper or cloth to touch the flex shaft and other
lubricated parts.
3. Wipe the old lubricant and material from the fl ex shaft.
Tip: Use motor spray (DYN5500) to break down the grease
buildup.
4. Lubricate the full length of the fl ex shaft assembly
up to the drive dog using Pro Boat Marine Grease
(DYNE4200). Also apply grease to the collet threads.
5. Carefully reinstall the fl ex shaft in the drive strut,
stuffi ng tube and collet. If the fl ex shaft is diffi cult to
remove from (or install into) the collet, rotate the fl ex
shaft to the right while pulling it from (or inserting it
into) the collet.
NOTICE: Do not rotate the flex shaft to the left inside the
coupler.
Ensure there is a 2mm gap between the drive strut and
drive dog to allow for flex shaft shrinkage under load.
NOTICE: Running the boat in saltwater could cause some
parts to corrode. If you run the boat in saltwater, rinse it
thoroughly in freshwater after each use and lubricate the
drive system.
NOTICE: Because of its corrosive effects, running RC boats
in saltwater is at the discretion of the modeler.
1. Pull and hold the Throttle Trigger to full throttle and
turn the ESC on.
2. After 2 seconds a “-B-B” will sound. Wait another 5
seconds and the ESC will give a rising tone to indicate
you have entered Programming Mode.
3. After entering Programming Mode, you will hear 4
tones in a loop indicating Programmable Items. Push
the Throttle Trigger to full brake within 3 seconds after
the tone sounds matching the programmable item
you want to select.
4. After selecting a programmable item, you will hear
several tones in a loop indicating Programmable
Values. Pull Throttle Trigger to full throttle to select the
value matching the tone. The ESC will give an alternat-
ing tone to indicate the item is selected.
5. Keep the trigger in Full Throttle to return to Step 3
and continue item selection. Move the throttle stick
to full brake position within 2 seconds to exit the
Program Mode.
The black-shaded setting is the factory default
Programmable Items
Programmable Value -B Single Beep B–– Long Beep
-B -B-B -B-B-B -B-B-B-B B––
B––
-B
B––
-B-B
B––
-B-B-B
Running Mode -B
Forward
Only
Forward/
Backward
Li-Po Cells -B-B Auto Calc. 2s 3s 4s 5s 6s
Low Voltage Cutoff
-B-B-B
None 2.8V/Cell 3.0V/Cell 3.2V/Cell 3.4V/Cell
Timing -B-B-B-B 0.00º 3.75º 7.50º 11.25º 15.00º 18.75º 22.50º 26.25º
ESC Programing
13
EN
30
-
INCH READY
-
TO
-
RUN BRUSHLESS BOAT