UL 19 Hydroplane PRB08028V2 30-INCH BRUSHLESS RTR Owners Manual • Bedienungsanleitung Manuel de l’utilisateur • Manuale dell’utente
EN NOTICE All instructions, warranties and other collateral documents are subject to change at the sole discretion of Horizon Hobby, LLC. For up-to-date product literature, visit www.horizonhobby.com or www.towerhobbies.com and click on the support or resources tab for this product.
EN Water-Resistant Boat with Waterproof Electronics Your new Horizon Hobby boat has been designed and built with a combination of waterproof and water-resistant components to allow you to operate the product in calm, fresh water conditions. While the entire boat is highly water-resistant, it is not completely waterproof and your boat should NOT be treated like a submarine.
EN Recommended Tools and Materials • • • • • • • • • • Needle nose pliers Paper towel Rubbing alcohol Open-end wrench: 10mm (2) Nut driver: 4mm, 7mm, 8mm Phillips screwdriver: #1 Hex wrench: 1.5mm, 2mm, 2.5mm, 3mm Clear tape (DYNM0102) Pro Boat® Marine Grease and Gun (DYNE4200) Hook and Loop Tape Set, WP 4pcs (DYNK0300) Product Inspection Carefully remove the boat and radio transmitter from the box. Inspect the boat for damage.
EN Canopy Removal 1. Loosen the 4 screws located at each corner of the canopy. 2. Remove the canopy py from the hull starting with the 2 rear screws. Ensure that the 4 screws ews have disengaged from es before carefully lifting the their bases canopy. Installing the Battery Packs The included electronics are rated for 2S–6S LiPo batteries; however, running the stock propeller nonstop on a 6S battery could overheat your electronics or damage your batteries.
EN Transmitter Functions Specifications Power Supply: 4 AA Batteries Operating Frequency: 2.4GHz Transmit Power: <100mw Control Protocol: SLT Control: Proportional Steering and Throttle/Brake with Trim Knobs, Third Channel with 3 Position Momentary Switch Auxiliary Functions: 3 Position Throttle Limit Switch, Steering Rate Knob to Change Steering Travel on-the-fly, Programmable Servo Travel for Steering and Throttle/Brake 1. Throttle Trim Adjusts the throttle neutral point 2.
EN Battery Charger Choose a charger designed to charge the recommended (2) Spektrum 7.4V 5000mAh 2S 100C Smart Hardcase LiPo Battery: IC5 (SPMX50002S100H5), or (2) Spektrum 11.1V 5000mAh 3S 100C Smart Hardcase LiPo Battery: IC5 (SPMX50003S100H5)We recommend the Spektrum Smart S2100 AC Charger, 2x100W (SPMXC1010). Refer to your charger manual for charging instructions and safety information. NOTICE: Never charge a battery in the boat or damage may result.
EN SPMSR315 Dual Protocol Receiver Specifications Type: Dual Protocol 3 Ch Receiver* (SLT/DSMR) Dimensions (LxWxH): 32.5 x 21.5 x 12.4mm Antenna Length: 90mm Channels: 3 Weight: 6g Band: 2.4GHz Voltage Range: 3.5–9.6V Bind Type: Bind Button Failsafe: Hold the steering wheel and throttle trigger in the desired failsafe positions during binding • BATT STR THR AUX 1 SPMSR315 receivers included with the SLT3 transmitter include SLT and DSMR compatibility.
EN Control Check IMPORTANT: Perform a control check at the beginning of each boating session, after repair, or after installation of new batteries. Ensure the receiver antenna is extended properly and all batteries are fully charged. 1. Power ON the transmitter and the boat. Do not install the boat canopy. 2. Place the boat securely on the boat stand. NOTICE: Do not operate the engine without water cooling circulation or damage may result. 3. Check steering and throttle on the transmitter.
EN Boating Tips When running your boat for the first time, we recommend calm wind and water conditions so that you can learn how the boat responds to your control. Maximum speeds are only achieved when the water conditions are smooth and there is little wind. A sharp turn, wind or waves can turn over a boat when it is moving quickly. Always pilot your boat for the wind and water conditions so that the boat does not turn over. Consult local laws and ordinances before choosing a location to pilot your boat.
EN After Boating and Maintenance • • • • • Drain water from inside the hull using the drain plug Fully dry the inside and outside of the boat, including the water cooling lines and jacket around the motor.
EN Rudder Service 1. Disconnect the water tube from the rudder. 2. Remove the nut, screw and linkage from the rudder arm. 3. Turn the rudder and loosen the set screw from the rudder pin. 4. Turn over the boat and lightly tap the rudder to remove the pin. 5. Assemble in reverse order. Propeller Service 1. Use an 8mm nut driver (DYN2805) to loosen the nut from the driveshaft. To secure the propeller while loosening the nut, hold the propeller. 2. Remove the nut and propeller from the driveshaft. 3.
EN Drivetrain Lubrication Always replace the drivetrain parts when they are damaged or show visible wear or injury and damage may result. Lubricating the flex shaft is vital to the life of the drivetrain. The lubricant also acts as a water seal, keeping water from entering the hull through the stuffing tube. Lubricate the flex shaft and propeller strut after every 30 minutes of operation and/or everytime you change the batteries. 1.
EN Troubleshooting Guide Problem Possible Cause Solution Boat will not respond to throttle but responds to other controls Throttle channel is reversed Reverse throttle channel on transmitter Damaged propeller, shaft or motor Propeller is out of balance Boat battery charge is low Boat battery is damaged Blocking or friction on shaft or propeller Replace damaged parts Balance or replace propeller Completely recharge battery Replace boat battery and follow battery instructions Disassemble, lubricate an
EN Limited Warranty What this Warranty Covers Horizon Hobby, LLC, (Horizon) warrants to the original purchaser that the product purchased (the “Product”) will be free from defects in materials and workmanship at the date of purchase.
EN Warranty and Service Contact Information Country of Purchase Horizon Hobby Horizon Service Center (Repairs and Repair Requests) Horizon Product Support North America (Product Technical Assistance) Sales European Union Horizon Technischer Service Sales: Horizon Hobby GmbH Phone Number/Email Address Address servicecenter.horizonhobby.com/ RequestForm/ productsupport@horizonhobby.com 2904 Research Rd Champaign, Illinois, 61822 USA 877-504-0233 websales@horizonhobby.
Replacement Parts / Ersatzteile / Pièces de rechange / Pezzi di ricambio Part # English Deutsch Français Italiano DYNM3831 3650 6 Pole Marine Motor 2000Kv 3650 6-poliger Bootsmotor 2000 kV Moteur 3650 6 Pôles Marine 2000Kv Motore marino 6 poli 3650 2000 Kv DYNM3875 Dynamite 120A BL Marine ESC 2-6S 120A Bootsempfänger 2-6 Contrôleur Brushless 120A 2-6S ESC marino brushless 120 A 2-6S PRB281053 Hull Rumpf Coque Scafo PRB281054 Canopy Kabinenhaube Cockpit Capottina PRB281055 Vertical
Recommended Parts / Empfohlene Teile / Pièces recommandées / Pezzi consigliati Part # English Deutsch Français Italiano DYN2801 Nut Driver: 4mm Mutterndreher: 4mm Tournevis p/écrou: 4mm Cacciavite a bussola: 4 mm DYN2803 Nut Driver: 5.
65739.1 Updated: 06/2021 ©2021 Horizon Hobby LLC. Pro Boat, the Pro Boat logo, DSMR, EC5, Dynamite, Reaction, Passport and the Horizon Hobby logo are trademarks or registered trademarks of Horizon Hobby, LLC. The Spektrum trademark is used with permission of Bachmann Industries, Inc. All other trademarks, service marks and logos are property of their respective owners. US 9,930,567. US 10,419,970. US 10,849,013. Other patents pending.
