User Manual

5
Note: Refer to the radio instructions for specific information on
transmitter setup.
It may be necessary to adjust the throttle trim knob to stop the
propeller from turning while the throttle trigger is in the neutral
position.
Throttle Trim
Adjust the rudder trim knob so that the rudder is centered prior to
operation. You may adjust this control to make the boat run straight
during operation.
Steering Trim
Section 4: Checking the Radio System
Section 3: Adjusting the Transmitter
Ensure the antenna tube is properly placed through the hull. It may
be necessary to slightly pull the antenna wire out to make certain the
radio range is sufficient.
Turn the transmitter on, then the receiver. Check for correct operation.
The rudder control arm should move toward the front of the boat when
right input is given. Conversely, when left input is given, the control arm
should move toward the back of the boat.
Left Turn
Left Turn
With the propeller free from any objects, give some throttle input to
ensure that the motor is working. If everything appears to be
functioning correctly, you are ready to run your boat!
Note: If you are transporting your boat, make sure you disconnect
the battery from the speed controller and then turn your
radio off until you are ready to run the boat. Once ready,
simply turn the radio on and plug the battery into the speed
controller, again making sure that the boat is in neutral.
Walk away from the boat. Actuate the rudder to confirm proper control
at least 30 feet from the boat prior to deploying the boat into the water.