User Manual
4
Carefully remove the hatch (scale pilot cockpit).
Make sure the receiver switch is in the "OFF" position. Install a fully
charged 7.2V Ni-MH battery pack into the radio box. Follow the
instructions included with your fast charger to ensure a safe charge.
Plug the battery into the female battery connector attached to the
electronic speed controller.
Install 4 AA alkaline batteries into the transmitter, following the
instructions provided for your radio system.
Turn on the transmitter, making sure that all three LEDs illuminate on
the power indicator and that the trim knobs are in the center position.
Turn the transmitter off.
Additional Required Items
You will need to purchase the following to get your boat on the water:
•4AAalkalinebatteriesfortheradiotransmitter
•7.2VNi-MHBatteryPackwithTamiyaConnector(DYN1050)
•ProphetSportIINi-MHBatteryPeakCharger(DYN4077)
Section 1: Installation of the Transmitter Batteries
Section 2: Installation of the 7.2V Ni-MH Battery Pack
Assembled Apache 24 EP RTR•
Pro Boat radio transmitter•
Boat stand•
Contents