User Manual

3
Thank you for purchasing the Pro Boat
®
Apache
™
24 Ready-To-Run
boat. Please read these instructions carefully before attempting to
operate your boat.
The Apache 24 comes Ready-To-Run with the Pro Boat 2.4GHz radio
system and electronic speed controller already installed. All assembly
and building is done at the factory, allowing you to quickly get your
boat running.
It is important that you read and follow this instruction manual, along
with the radio system manual before you run this exciting boat. Failure
to read and understand the manual could result in personal injury,
property damage or permanent damage to your boat. It is also
important to run your boat responsibly. With proper care and
maintenance, you will be able to proudly enjoy your Apache 24 for
many years to come.
When operating the boat, stay clear of people, full-scale boats,
stationary objects and wildlife. It is preferable to operate the Apache
24 in low wake, low wind conditions and in areas free of people,
wildlife and objects.
Before you operate your model, make sure that your frequency is clear.
If someone is operating on the same frequency, both models could go
out of control, possibly causing damage to the models or to others.
Check all of the hardware, and the propeller for damage and loose
screws before and after each run.
If at any time while operating your model you sense any abnormal
function, end your operation immediately. Do not operate your boat
again until you are certain the problem has been corrected. Always
stay clear of the propeller.
Age Recommendation: Not for children under 14 years.
This is not a toy.
Safety, Precautions, and Warnings
As the user of this product, you are solely responsible for operating it
in a manner that does not endanger yourself and others or result in
damage to the product or the property of others.
Carefully follow the directions and warnings for this and any optional
support equipment (chargers, rechargeable battery packs, etc.) that
you use.
This model is controlled by a radio signal that is subject to interference
from many sources outside your control. This interference can cause
momentary loss of control so it is necessary to always keep a safe
distance in all directions around your model, as this margin will help to
avoid collisions or injury.
Always operate your model in an open area away from people.•
Avoid operating your model where injury or damage can occur.•
Never operate the model out in populated areas for any reason.•
Never operate your model with low transmitter batteries.•
Carefully follow the directions and warnings for this and any •
optional support equipment (chargers, rechargeable battery
packs, etc.) that you use.
Keep all chemicals, small parts and anything electrical out of •
the reach of children.
Moisture causes damage to electronics. Avoid prolonged •
water exposure to all equipment not specifically designed and
protected for this purpose.
Carefully remove the boat and radio transmitter from the box. Inspect
the boat to make sure no damage is present. If you notice damage is
present, please contact the hobby shop where you purchased it.
Introduction
General Guidelines
Specifications
Inspection
Hull Length ........................24 in (609mm)
Beam . . . . . . . . . . . . . . . . . . . . . . . . . . . . 8.5 in (216mm)
Motor . . . . . . . . . . . . . . . . . . . . . . . . . . . . Water-cooled High-performance 550-size
Radio System ......................Pro Boat 2.4GHz Pistol-grip Transmitter
Drive System . . . . . . . . . . . . . . . . . . . . . . Direct Drive
Steering System ....................Steerable Drive System
Speed Control ......................Waterproof Electronic with Reverse