Installation Manual

For further information on installation instructions and warnings please visit our website WWW.PROARMOR.COM or contact

Customer Service at 1-888-31-ARMOR

LIMIT STRAP INSTALLATION:

Wrap the limit strap around the chassis tube that the lower door mounts to like

shown in the pi

cs below.

Once the strap is around the tube connect it to the back lower panel mount using the

supplied M6 ac

orn nuts and button-head flanged bolts. NOTE: Make sure the Pro

Armor logos ar

e in the correct orientation.

Fully tighten all hardware and repeat steps for the opposite side. Product installation is now complete.

NOTICE

- Check to be sure that the doors and vehicle frame are correctly aligned. If the doors and frame are not aligned properly, the

door latch catch and paddle latch may not be aligned and the paddle latch may not fully engage and/or the door may not close

completely. Inspect the doors and check to see that the door latch catch and paddle latch are aligned properly and that the

paddle latch fully engages when the door shuts before each use.

All hardware should be fully tightened. Do not over-torque or hardware may weaken or break.

Inspect the door latch catch and paddle latch to see that they are not cracked, bent, corroded, or otherwise damaged. Inspect

to confirm that they are both fully operational.

Have an authorized dealer or trained technician inspect the door alignment and latch interface after a collision or in the event of

any damage.