Installation Manual

For further information on installation instructions and warnings please visit our website WWW.PROARMOR.COM or contact
Customer Service at 1-888-31-ARMOR
FIGURE 4
8.
Bring the door to the closed position with the latch fully engaged
on the door latch catch. Fine tune the adjustment of the door
frame, paddle latch plate assembly, and door latch catch until you
can open and close the door smoothly without any binding. Once
this is done, you can proceed to fully tighten all hardware. Refer to
fig #4.
Repeat these steps for the opposite side.
6.
Use the 4mm allen key to tighten the 3 M6 button-head
flanged bolts on the paddle latch plate assembly. Use a 15mm
wrench to tighten the cage tube connector bolts. Double check
to make sure the door is still in good alignment to open and
close smoothly without any binding. Use a 13mm wrench to
get to the back-side nut of the lower mounting bracket and a
13mm socket on the outside. Tighten down and make sure the
door still opens and closes smoothly.
7.
5.
You will now adjust the position of the door do make sure it
opens and closes smoothly. Loosen the T40 torx bolts that
secure the door latch catch.