Manualshelf

Installation Manual

ManualsBrandsPro Armor ManualsAutomotivePro Armor RZR XP 1000 Black Bolt On Traditional Door P141D000BL
1234567
For further information on installation instructions and warnings please visit our website WWW.PROARMOR.COM or contact
Customer Service at 1-888-31-ARMOR
DOOR INSTALLATION:
1.
Install the top door bracket around the cage tube connector
with the bolts removed.
2.
Push the stock cage bolts through the door bracket and the
cage tube connector. Thread the nuts onto the bolts, but
do not tighten yet. See fig #1.
3.
The rear lower mount is a tight fit to get through the plastics,
so you will need to pull the plastic back slightly to prevent it
from getting scratched and slide the bracket into place. See fig
#2. Use the supplied M8 nyloc nut and bolt. Do not tighten yet.
4.
Once both mounts are snug but not fully tightened,
install the paddle latch plate assembly onto the door.
See fig #3. Use the supplied M6 button-head flanged
bolts. Do not tighten yet.
FIGURE 1
FIGURE 2
FIGURE 3