Instructions / Assembly

- 12 -

4. When the backwash cycle is complete, the valve will advance to the brine draw (BD) position. Once the valve

reaches the BD cycle, push and release the “Cycle” button. The display will show “GOTO RR” (Rapid Rinse).

Once the valve reaches the rinse cycle, allow the water to run for the entire rinse cycle

5. When the rinse cycle is complete, the valve will advance to the “BF” position. Once in the brine ﬁll position,

check that the control valve is pushing water into the brine tank (remove brine well cap to conﬁrm that the

water level is rising in the brine tank). Allow the valve to reﬁll for the full amount of time as displayed on the

screen to insure a proper brine solution for the next regeneration.

6. When the reﬁll cycle is complete, the valve will automatically advance to the SERVICE position. Open the outlet

valve on the bypass, then open the nearest treated water spigot or faucet (remove faucet screen to prevent

clogging) and allow the water to run until clear, close the tap and replace the faucet screen.

1. Setting Time of Day

Default setting 12:00 (24 hours)

Press Settings Button and Up Button

simultaneously to enter into Programing

Mode

Set the hour

Set the minutes

11:30

SET- 1TIME

Flashing

11:30

Flashing

Press Simultaneously

Press the Settings Button to accept and

continue.

Press Up or Down buttons to

change hours.

Press the Settings Button to accept and

continue.

Press Up or Down buttons to

change minutes.

11:30

Flashing

VALVE PROGRAMING CONT.

Programing Unit