Product Manual

Section 4 Analyzer Setup

Press Menu from the Initial Screen to display the screen below.

Select options by pressing ▲ or ▼ until the Selection Arrow (→) is next to the

option. Press ENTER to show the options in a new screen or cycle through the

settings below. Select Exit and press ENTER to return to the Initial Screen.

Test Settings

Select Test Settings to display the menu shown below.

Press ▲ or ▼ to select an option. Press Enter to show or change the option

settings below. Select Exit and press Enter to return to the Main Menu.

2P, 4P, 7P, and 10SG are examples of Type of Strips. Refer to Appendix 2 for

actual Analyzer-Read Type of Strips.

Type of Strip 2P, 4P, 7P, and 10SG

Mode Routine, STAT, QC

Test Number

User selected number

Continuous Test On, Off (single test)

Operator ID

If User Login is off, Operator ID will be 01 through 10.

If User login is enabled, Operator ID will be 11

through 20, and 100 for the Administrator

Units Conventional Units or Standard International (SI)

Type of Strip

Select Type of Strip and press ENTER to change the strip type. Each strip type

name defines the number of test parameters. If User Login is enabled and

Operator ID is 11 through 20, this setting cannot be changed.

Refer to Appendix 2 for a detailed list of available parameters.

Note: Ensure the type of strip selected corresponds with the strip to be

used. If it does not, an error message will be displayed.