Product Manual

24
Press START after the ID has been entered to display the next screen.
Press START again to begin strip testing. The strip is tested the same as other
single test modes. The results screen will show the sample ID in the ID field.
If Auto-print is Off, press PRINT from the results screen to print results. Press
CANCEL to return to the previous barcode entry screen.
Strip Test – Continuous Test Mode with Barcode Reader
If Barcode Reader is On and is displayed, samples are tested in batch mode.
Holding the Barcode Reader over the barcode on the specimen container, press
the Scan button on the Barcode Reader. A red illuminated line will appear over
the barcode to be read. Move the Barcode Reader to align the red line over the
barcode. When the Barcode Reader beeps the barcode has been scanned. All
sample barcode IDs in a batch are read and stored in memory in sequence.
Samples must be run in the same sequence as scanned. This ensures IDs and
samples correspond. Prompts are displayed to show the next sample to be
tested.
Press START to begin the batch mode.
Press CANCEL to return to the Initial screen.
Press ENTER to enter a new screen to edit the Barcode ID.