Product Manual

17
Section 5 Analyzer Operation
If User Login is not enabled, the Initial Screen will be shown after Self Test.
Refer to Section 3 Initial Startup.
If User login is enabled, the analyzer will display a login screen after Self Test.
Enter the ID and enter or scan the Passcode. Press ENTER to run the analyzer.
Press CLEAR to return to the login screen.
If the Passcode is incorrect, the analyzer will indicate a passcode error. After 3
seconds, the screen will return to the login screen.
If the Passcode is correct, the analyzer will display the Initial Screen. The
logged-in ID will be shown (11-20, or 100).
The user ID will be 11-20 for Operators. This provides access to operate the
analyzer, change test modes and test number, and review settings. Press
CLEAR from the Initial Screen to logout and display the Login Screen.
The user ID will be 100 for the Administrator. This provides full access to operate
the analyzer and change settings. Press ENTER from the Initial Screen to display
the ID Admin Screen. Press CLEAR from the Initial Screen to logout and display
the Login Screen.
Press START on the Initial Screen to test strips. Check all settings and strip types
before testing.